Linde T 16, Руководство по эксплуатации

Страница: 23 / 53

3
6
0
8
0
4
2
5
1
1
-
0
5
0
4
Driving
CAUTION
Always adapt your driving to the cond itions of the
surface concerned (irregularities, etc.), as well
as to any particularly dangerous working areas
and the nature of the load being carried.
ATTENTION
In order to avoid any scraping of the lifting system
against the ground, always raise the forks to
mid-height before setting off.
ATTENTION
Always turn off the power and remove the key
before leaving the truck.
Instructions for use
The T 16, T 18 and T 20 pallet trucks are designed to be
used inside non-dangerous atmospheres; the ambient
temperature must be between -10°C and +40°C and the
relative humidity of the air must be less than 95%.
NOTE: For lower temperatures, there is a cold-room va-
riant.
The ground must be level. Ground clearance at the lowest
point is approx. 9 mm, but the T 16-T18-T20 can cope with
clearance angles of up to 27° with the lifter in the upper
position.
The resistance of the ground to indentation must be
approx. 37daN/cm
2 (boggie),54daN/cm² (load wheel)
The maximum negotiable gradient recommended for short
distances is 10%, for reasons of braking and stability.
The machine may only be used with pallets weighing a
maximum of 1.6 t, 1.8 t or 2 t according to the model,
distributed evenly over the whole length of the fork arms
Loads must be uniform, with a maximum recommended
height of 2 m.
For applications other than the above, please consult your
local representative.
Use
1
2
2
3
1
4 5
Starting
- Connect the battery plug.
- The discharge indicator (2) lights up.
- Turn the key switch (1) fully to the right.
NOTE
Always adapt your driving style to the roadway used
(rough surfaces, etc.), to particularly hazardous working
areas and to the load.
Operate the truck only on ground and floors with a sufficient
load capacity.
Contact your distributor before driving on long slopes.
The climbing ability values given in the data sheet are
derived from the tractive force and apply only for cro ssing
obstacles and for short differences in height.
Indication of direction of travel
- Tilt the til ler into are a ( 1)
The directional markings conventionally used on pallet
trucks are as follows:
- Forward travel < (4)
- Reverse travel > (5)
CAUTION
Before negotiating any tight bend, the truck must
be slowed down. Taking a tight bend too fast
may cause the truck to topple over.
WARNING
The bumper of this machine is designed to
protect the driver’s feet. This protection is
completely effective if the driver is wearing safety
shoes.
TAKE CARE
Always keep your hands on the controls and
never place them near moving parts without
disconnecting the battery.
https://www.besttruckmanuals.com/