Lexmark Optra N 4040, Справочное руководство, Страница: 68 / 259

4033
3-5
4033
Diagnostic Aids
Sample Print Test (Models 20X and 30X)
Press and release the Test button to send a single-page file to all ports.
If the test is successful, go to “LAN Connection Check” on page 3-6. If
the print test fails, go to “Wrap Test for Adapter Ports” on page 3-5.
Wrap Test for Adapter Ports
To test any port:
1. Disconnect the printer cable from the adapter.
2. Install a wrap plug on that port.
3. Press Reset.
Models 0XX:
The Status LED will blink several times within 3 to 4 seconds, turn off for
up to 10 seconds, then blink continuously in a pattern of two blinks, a
pause, then two blinks. Any other blinking pattern indicates a failure of
the test. Replace the adapter if the test fails.
A successful test results in only the Power and Status LEDs on, just like
a normal Reset. Replace the adapter if the test fails.
Models 20X and 30X
Status Test Data Failure
off off blink Parallel 1 port wrap failure
off blink off Parallel 2 port wrap failure
off blink blink Serial port wrap failure