51
S E C T I O N 9 • O p e r a t i n g I n s t r u c t i o n s
Refer to Section 9.3,
Replace the Gas Vent/Filter Assembly.
5
If no warning signals are active, the Fluid Warmer with Air
Detection and Pressure Chambers is ready for use.
6
Open the remaining Disposable Set clamps, slowly open the
roller clamp, and reestablish fluid flow to the patient.
For more information on the following alarm conditions, refer to Section 8,
Operation:
• Over Temperature Alarm
• Check Disposables Alarm
• Check Tubing Alarm
• Add Recirculating Solution Alarm
9.5 After Use
1
Discontinue infusion.
2
Turn the Fluid Warmer OFF.
3
Release chamber pressure before opening the Pressure Chamber
door:
a
Move the lever to the minus (–) unpressurized position.
This will release the pressure in the chamber and
deflate the bladder.
b
Open door and remove the fluid bag.
4
Remove the Disposable Set from the Fluid Warmer.
5
Dispose of the Disposable Set in a safe manner according to local
guidelines for disposal of contaminated medical waste.
6
Visually check the condition of the device. Remove from service
any unit that shows physical damage.
7
Clean the device with warm soapy water.
| Operator’s Manual
Содержание H-1200 115V
