level 1 H-1200 115V, Руководство оператора

Страница: 45 / 82

3
Move the pinch clamp on the Patient Line of the Gas Vent/Filter
Assembly next to the Luer connector. Close the pinch clamp.
Note:
Disposable Sets use two types of Gas Vent/Filter Assemblies as
shown in the following table. Step 4, which describes how to install the
Gas Vent/Filter Assembly, is different for each type of Disposable Set
and for the H-1200 and H-1000 Fluid Warmers. Continue with the
appropriate step 4 that applies for your specific Disposable Set and
Fluid Warmer.
Types of Gas Vent/Filter Assemblies
Disposable Set Gas Vent/Filter Assembly Type
DI-55, D/DI-65HL, D/DI-75, F-50
D/DI-150, and D/DI-350
DI-50, D/DI-60 HL, D/DI-70, F-10/F-30
D/DI-100, and D/DI-300
Step 4 — H-1200 Fluid Warmer with DI-55, D/DI-65HL, D/DI-75,
D/DI-150, and D/DI-350.
4
Install the Gas Vent/Filter Assembly. Refer to the series of figures
on the left.
a
Open the #3 Clamp Slot door—push down on the
tab (a).
b
Lift up the front of the door (b).
c
Pull the door down (c) and away from the Clamp Slot.
d
Align the Gas Vent/Filter Assembly to the #4 Block, (d)
and press it into place.
e
Press the clip at the top of the Gas Vent Vent/Filter
Assembly (e) to the bottom of the Heat Exchanger.
f
Insert the Patient Line in the Clamp Slot (f) and push it
back into the slot.
g
Hold the Patient Line in the Clamp Slot and push the
door up (g) to engage the top hinge.
h
Push the front of the door down (h) to close it.
| Operator’s Manual
S E C T I O N 9 • O p e r a t i n g I n s t r u c t i o n s
39
F-50
b
a
c
f
h
g
d
e