|
Operator’s Manual
b
• For 100 - 120V Fluid Warmers,
Remove the fuse and verify that T6.3AL250V (time lag,
6.3 amp, 250V fuse), is printed on one of the silver end
caps, if not replace the fuse with a new fuse marked
T6.3AL250V.
•
For 220 - 240V Fluid Warmers,
Remove the fuse and verify that T3.15AL250V (time lag,
3.15 amp, 250V fuse), is printed on one of the silver end
caps, if not replace the fuse with a new fuse marked
T3.15AL250V.
4
Replace the back panel and insert all but 6 of the screws (
a
)
as indicated in Step 1 below. Then proceed to install the
Air Detector/Clamp.
To install the Air Detector/Clamp,
1
Remove 6 screws (
a
) from the rear of the Fluid Warmer,
lower left side, from locations shown in figure.
2
Plug in the power cord (
b
) of the Level 1
®
H-31, Version B,
Air Detector/Clamp into the auxiliary MAINS outlet located
on the bottom of the Fluid Warmer.
Note:
If you turn the Fluid Warmer off and the Air
Detector/Clamp does not turn off, contact Smiths Medical
or your local Smiths Medical distributor.
3
Loosen the three screws holding the mounting bracket to the
rear of the Air Detector/Clamp (do not remove).
4
Align the slot on the Air Detector/Clamp with #3 Block on
the Fluid Warmer (
c
). Fit in place over the block.
Note:
Do not bend the mounting bracket while holding the
Air Detector/Clamp against the fluid Warmer.
5
Carefully align the mounting bracket on the rear of the Air
Detector/Clamp with three screw holes, shown (
d
). Ensure
that the gasket seal on the Air Detector/Clamp is flush with
the Fluid Warmer. Insert three flat-head screws and tighten,
securing the Air Detector/Clamp to the Fluid Warmer.
Tighten the three screws on the mounting bracket on the
Air Detector/Clamp.
6
Locate three power cord clips (e) included with the Air
Detector/Clamp and snap onto power cord. Align clips with
the three screw holes as shown, insert screws, and tighten.
S E C T I O N 5 • O u t o f t h e B o x — A s s e m b l y
16
d
a
e
a
a
a
c
a
a
e
e
Содержание H-1200 115V
