LESsoft configuration software
Leuze electronic
LES 36
74
TNT
35/7-2
4
V
9.4
Parameter settings/Parameters tab
Click on the
Parameters
tab to access the parameter settings:
Figure 9.3:
Parameter settings LESsoft
The LES is adapted to applications in the
Parameters
tab (
Standard
tab). First go to the
Task Parameters
panel and set the values required for operating the LES. Then go to
the
Analysis Functions
panel and define analysis windows (EAWs, AWs) for edge and
object detection.
Finally, save these settings as an
Inspection Task
by clicking on
Apply Settings
or
Transmit to Sensor.
The analog output is configured in the
Analog Output
9.4.1
Standard tab - Task Parameters panel
Inspection Task Selection
In the
Inspection Task Selection
panel, you can select inspection tasks.
Note!
By default, changeover of the inspection tasks via the PROFIBUS master (PLC) has priority
over LESsoft. In this field, the
selection
of the inspection task with LESsoft is only possible
if, under
Global Parameters
there is
no
tick in front of
Enable External Inspec-
tion Task Selection
. Otherwise, the inspection task can only be selected via the pro-
cess interface.
By removing the tick in the
Enable External Inspection Task Selection
check
box, the inspection task cannot be changed via the process interface while configuration is
being performed. After configuring with LESsoft and before transmitting the settings to the
