Lenovo ThinkStation P330, Руководство пользователя

Страница: 93 / 134

c. Align the four holes in the rear of the type-2 storage-drive cage with the corresponding hooks in the
drive bay assembly. Then slide the type-2 storage-drive cage upward until it snaps into position.
Reinstall the screw to secure the type-2 storage-drive cage.
Figure 104. Installing the type-2 storage-drive cage
d. Connect the signal cable and the power cable to the new storage drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 89.
Heat-sink-and-fan assembly
Attention: Do not open your computer or attempt any repair before reading and understanding the
Appendix A “Important safety information” on page 97.
CAUTION:
Avoid contact with hot components inside the computer. During operation, some components
become hot enough to burn the skin. Before you open the computer cover, turn off the computer,
disconnect power, and wait approximately 10 minutes for the components to cool.
To remove or install the heat-sink-and-fan assembly, do the following:
1. Prepare your computer. See “Preparing your computer” on page 24.
2. Lay the computer on its side for easier access to the system board.
3. To remove the heat-sink-and-fan assembly, do the following:
a. Disconnect the heat-sink-and-fan assembly cable from the microprocessor fan connector on the
system board.
Chapter 6
.
Hardware removal and installation
87