Leica GR10, Руководство по эксплуатации

Страница: 135 / 317

Printed Documentation
Logging session wizard: Session timing
Background information
Timed logging sessions consider the configured file length and the configured interval length.
Example:If a timed logging session is configured to
•
Start logging at a certain date at 15:00h
•
End logging after 30min
•
No of repeats: repeat 10 times
•
Start next session: 10 min after last session ended
•
And the file length is set to 1h, the behaviour will be as follows:
1.
The receiver starts logging at 15:00h because the first interval starts.
2.
The receiver stops logging and closes the file at 15:30h because the first interval ends.
3.
The receiver starts logging into a new file at 15:40h because the second interval starts.
4.
The receiver closes this file at 15:59:59h and immediately starts a new file because of the 1h file rollover.
5.
The receiver stops logging and closes this file at 16:10h because the second interval ends.
Setting Descriptions
The table below describes the settings that can be configured on the Session timing page.
Please note that the time settings will refer to the receivers defined
Time zone
. To set the receivers
Time zone
, go to
GNSS management / Site name and coordinates .
Setting Description
Start logging at
Configure the start time and data of the logging session.
Use the date and time pickers to select the logging start time.
End logging
Configure the end time and data or the duration of the logging session.
End logging
•
at:
Select a time and date for the first logging interval to end.
•
after:
Select a time interval after which the first logging interval
ends.
•
no end:
The logging session starts at the defined date and time,
and runs continuously.
The minimum time interval for a logging session to run is 5 minute.
No. of intervals
Configure the number of repeats for the current logging session.
This setting is only available if
End logging
is set to
at
or
after
.
134