Leguan 135 NEO, Руководство оператора и по обслуживанию

Страница: 22 / 66

22
OPERATION
Read this Operator
’ s Manual and the Operator ’ s Manual for the engine carefully before
commencing operation. Read the safety instructions in this manual and make sure you
understand them before commencing operation.
It is the operator’s responsibility to
understand and follow all operating and safety instructions. An access platform is designed only
for the lifting of persons and their equipment; its use for any other purpose is prohibited for
reasons of safety. If more than one person uses the machine during a shift, all of them must be
qualified to do so and they must comply with the operating and safety instructions and rules.
Starting the combustion engine / electric motor
1. Switch on the machine by turning the ignition switch (figure 8) and select preferred control
position (lower controls or platform controls)
2. Open fuel faucet (see the engine manufacturer’s manual).
3. If using the electric motor, connect 230 V 16 A cable and check the residual current device.
The RCD-unit TEST button can also be used to test the power supply
4. Attach the safety harness to the attachment points and close the gate.
5. Switch on the petrol engine or electric motor by pushing the ignition button for desired power
source
6. Use choke only if the petrol engine doesn’t start automatically (figure 7, switch 21 or lower
controls figure 8, switch 8)
7. Engine or electric motor is turned off by pushing either of the ignition buttons once.
NOTE! The engine must always be switched off using the ignition button.
NOTE! When you use the machine’s electric motor, use an extension cord
with a maximum length of 20 m and a minimum wire cross sectional area of
2.5 mm
2
. Buildings’ fixed electrical wiring may affect the functioning of the
electric motor.
Use only lower speeds if the electric motor doesn’t work properly.
Start-stop function
Machine is equipped with automatic start-stop function. Petrol motor rpm is lowered to the
idle and electric motor is stopped when the either of the motor is on and machine is idling (no
movements are done). When machine is idling engine run light (between motor start buttons)
is blinking. Motors will wake up from idle automatically when allowed movements are done
again.