Leguan 135 NEO, Руководство оператора и по обслуживанию

Страница: 13 / 66

13
Risk of tipping over
-
Exceeding the access platform’s maximum load or additional load or the maximum number of
people permitted on the platform is strictly prohibited.
-
When wind speed is equal to or greater than 12.5 m/s (28 mph), the use of the access platform
must be discontinued immediately, and the platform must be lowered down to the transport
position.
-
Ensure that the access platform is used on dry, solid, level ground only. The ground is solid
enough if it can carry min. 3 kg/cm
2
. On softer ground, use extra support plates under the
outriggers.
-
Do not use a ladder, chair, stool, scaffolding or any other means to increase the reach
capability of this access platform.
-
If the platform gets stuck or jammed, or it is too close to a building or a wall to be moved, do
not try to release the platform by operating the controls. All persons must leave the platform
first (with the help of a rescue service or fire brigade if necessary), only after that one can try
to lower the platform by using the emergency lowering.
-
Do not increase the area of the platform or the load. Increasing the area exposed to wind
weakens the stability of the access platform.
-
Weight must be equally distributed across the platform. Make sure that additional weight
cannot shift on the platform.
-
Do not drive on gradients that are steeper than the max. values given for this access platform
and for the slope.
-
Never use this access platform as a crane. This access platform is intended for lifting the max.
allowed number of persons and additional load only.
-
Check and make sure that all tyres are in good condition. If the tyres are full of air, make sure
that there is correct pressure in the tyres.
-
To ensure the safe operation of this access platform the manufacturer has conducted
approved tests for the
LEGUAN 135 NEO in accordance with the standard EN
280:2013+A1:2015 static stability test in accordance with paragraph 6.1.4.2.1 and dynamic
overload test in accordance with paragraph 6.1.4.3 of the EN 280:2013+A1:2015.
Risk of falling
-
When working with the access platform, the operator(s) should always wear a certified safety
harness which is properly connected to the platform.
-
Do not stretch or reach out over the handrails. Stand steadily on the platform floor.
-
It is not allowed to go to or step out from the platform when the booms are lifted.
-
Keep the platform floor clean.
-
Always close the platform gate before commencing operation.
Risk of collision
-
Adjust the drive speed so that it is safe with regard to the ground conditions.
-
When operating the lift, take into account that visibility may be limited
-
The operator must follow all regulations concerning the use of safety equipment on the work
site