BILS-10003 rev E
32
505
Parameter Table
Parameter
Sample
Value
Password
Level
Description
00 System Mode
1
Level 1
Allows the user to change system modes.
0=Off Mode
– turn system off
1=UPS Mode(automatic)
– Will condition input power and when
needed, turn on battery power
2=Line Condition mode
– Will condition input power but will not
transfer to battery power. Battery power is inhibited.
3=Battery Mode
– System will only run on battery power.
4=Charger Mode –
When AC Line is applied to UPS - turns on
battery charger There will be no UPS output, but the battery charger
will charge the battery. System Mode 4 is valid on 6-20kVA models
only.
01 AC Volts In
Actual
Level 2
Displays the measured RMS voltage of input power to the UPS
02 AC Volts Out
Actual
Level 2
Displays the measured output voltage of the UPS. Note: Will display
120 VAC nominal (half of the 120/240 VAC output)
03 AC Amps out
Actual
Level 2
Displays the measured AC output current (amps) of UPS
04 KVA Power out
Calculated
NP*
Displays the calculated kilo-volt amps (kVA) load on output of UPS
05 KW Power out
Actual
Level 2
Displays the measured kilo-watts (kW)of load on output of UPS
06 Percent Load
Calculated
NP*
Displays the calculated percent of load on output of UPS
07 Power Factor
Calculated
NP*
Displays the ratio of watts to volt-amps of load on output of UPS.
08 Spike Volts
Actual
Level 2
Displays the measured peak voltage of input power of UPS
09 AC Frequency
Actual
NP*
Displays the actual frequency of input power of Herytage UPS
10 Future Use
NP*
11 Future Use
NP*
12 Future Use
NP*
13 Future Use
NP*
14 Future Use
NP*
15 Vin minimum
Level 1
Displays the lowest RMS voltage measured on input power to UPS
since last reset
– to reset, install password, display parameter, and press clear
16 Vin maximum
Level 1
Displays the Highest RMS voltage measured on input power to UPS
since last reset.
– to reset, install password, display parameter, and press clear