Leader LV 5837, Инструкция по эксплуатации

Страница: 39 / 106

5. SYSTEM SETTINGS
31
F•1
5.2 Configuring the Ethernet and Remote Settings (LV 5838 only)
To configure the Ethernet and remote settings, use the ETHER&REMOTE tab.
These settings are not initialized when you press SYSTEM and then F•7 INITIALIZE.
[Reference] See section 11,
“REMOTE CONTROL (LV 5838 ONLY)” and section 12, “ETHERNET
CONTROL (LV 5838
ONLY).”
→
SYSTEM SETUP
→
NEXT TAB
→
Figure 5-3 ETHER&REMOTE tab
● Ethernet: DHCP / IP
Select how to set the IP address.
If you select IP, set the IP address, subnet mask, and gateway below.
If you select DHCP, these are set automatically.
This setting is enabled after you restart the LV 5838.
● Time Server: ON / OFF
Select whether to enable the time server function.
When set to ON, set to the IP address of the time server in IP Address and the appropriate
clock adjustment value in Time Zone.
● SNMP: ON / OFF
Select whether to enable the SNMP function.
● ACCESS: RO / RW
Select the SNMP access mode.
RO enables you to only read the settings; RW enables you to read and write the settings.
● SNMP Trap: OFF / ON
Select whether to enable trap output.
● Alarm Polarity: Positive / Negative
Select the polarity of the alarm signal that is transmitted from the remote connector.
● Select: Recall / Recall and 5838_02 / 02
Select the remote connector operation mode.
F
•3
SYSTEM
USO
RESTRITO