Leader LV 5837, Инструкция по эксплуатации

Страница: 29 / 106

4. BEFORE YOU BEGIN MEASURING
21
4.2.4 External Reference Signal Input (LV 5838 only)
Figure 4-6 EXT REF INPUT
Apply a tri-level sync, NTSC/PAL black burst signal,10 MHz sinusoid signal, or 48 kHz word
clock signal to the EXT REF INPUT connector on the rear panel.
On the GENERAL tab in the system settings, specify EXT-REF INPUT FORMAT SETTING.
[Reference] GENERAL tab → See section 5.1, “General Settings.”
4.2.5 Headphone Output
● Selecting the Channels to Output
Select the channels using PHONES on the assign menu. The selected channels are
indicated in the upper right of the display.
[Reference] PHONES → See section 4.4.7, “Mapping Measurement Channels.”
● Adjusting the Volume
Use the VOLUME knob on the front panel to adjust the speaker output volume. Pressing
the knob returns the volume to its normal setting.
The current volume is indicated in the upper right of the display.
Low volume
・・・
Normal volume
・・・
High volume
● Connecting a Headphone
Connect a headphone (mini plug) to the headphone jack on the front panel.
Check the volume before you put the headphones on.
4.2.6 DVI-D Output (LV 5838 only)
Figure 4-7 DVI-D OUTPUT
The DVI-D output connector on the rear panel transmits the LV 5838 screen image. Using a
DVI-D cable sold in the market, connect the LV 5838 to an VGA (640 × 480) display.
USO
RESTRITO