67
12. ETHERNET CONTROL (LV 5838 ONLY)
F•1
12. ETHERNET CONTROL (LV 5838 ONLY)
The LV 5838 can be remotely controlled through its Ethernet port on the rear panel.
Controlling an LV 5838 remotely through its Ethernet interface has only been confirmed to work
in a local network environment. LEADER does not guarantee that this feature will work in any
network environment.
12.1
TELNET
From a PC connected to the same network as the LV 5838, you can remotely control most of
the operations that can be controlled from the panel.
12.1.1
Procedure
1.
On the ETHER&REMOTE tab, set the IP address.
[Reference] See section 5.
2, “Configuring the Ethernet and Remote Settings (LV 5838 only).”
→
SYSTEM SETUP
→
NEXT TAB
→
Figure 12-1 ETHER&REMOTE tab
2.
Press
COMPLETE.
3.
Restart the LV 5838.
If you didn't make any changes, you do not have to restart.
4.
Connect the LV 5838's Ethernet port to the network.
Use a UTP cable (category 5).
5.
On the PC, start a TELNET client.
On Windows XP, on the taskbar, click Start, and then click Run. Type
“TELNET “ and
the IP address that you set in step 1. Then, click OK.
F
•3
SYSTEM
F•1
USO
RESTRITO
Содержание LV 5837
Страница 1: ...LV 5838 LV 5837 AUDIO MONITOR INSTRUCTION MANUAL USO RESTRITO...
Страница 98: ...12 ETHERNET CONTROL LV 5838 ONLY 90 26 AUD_VALIDITY_ERR AUDIO Validity error detection USO RESTRITO...
Страница 101: ...12 ETHERNET CONTROL LV 5838 ONLY 92 Country or region Time Zone Kiribati Line Islands Tokelau 14 00 USO RESTRITO...
