Lantronix EDS32PR, Руководство пользователя

Страница: 140 / 163

14: Tunneling
EDS User Guide
140
Command Description
'+++'.
ATEn Switches echo in Command Mode (off - 0, on - 1).
ATH Disconnects the network session.
ATI Shows modem information.
ATQn Quiet mode (0 - enable results code, 1 - disable results code.)
ATVn Verbose mode (0 - numeric result codes, 1 - text result codes.)
ATXn Command does nothing and returns OK status.
ATUn Accept unknown commands. (n value of 0 = off. n value of 1 =
on.)
AT&V Display current and saved settings.
AT&F Reset settings in NVR to factory defaults.
AT&W Save active settings to NVR.
AT&Z Restore active settings from NVR.
ATZ Restores active settings from defaults.
ATS0=n Accept incoming connection.
n value of 0 = disable
n value of 1 = connect automatically
n value of 2+ = connect with ATA command.
ATA Answer incoming connection (if ATS0 is 2 or greater).
A/ Repeat last valid command.
For ATDT and ATDP commands from 1 to 255, the EDS uses the configured
Connect Mode remote station address and replaces the last segment with the
number provided. The same applies if two segments are provided. For example, if
the configured address is 100.255.15.5, entering “ATDT 16.6” results in
100.255.16.6.
When using ATDT and ATDP, enter 0 to switch to the Command Line Interface (CLI).
Once the CLI is exited, the EDS reverts to modem emulation mode.
Configure either the IP address using the address (<xxx.xxx.xxx.xxx>), or the
IP address and port number <xxx.xxx.xxx.xxx>:<port> . The port number
cannot be entered on its own.
—Or—
You may specify a hostname instead of an IP address.
Serial Line Settings
Serial line settings are configurable for both serial Line n and serial line 2.
Configure the buffer size to change the maximum amount of data the serial port
stores. For any active connection, the EDS sends the data in the buffer.