LANCIER Monitoring RTS 1000D, Руководство по эксплуатации

Страница: 44 / 68

Page 44
The line item numbers ( bold, italic , not in brackets) in chapter "1 Servicing compressor" relate to the explod-
ed drawing of the compressor on page 41.
1. Servicing compressor VD 50/4 (RTS 5200D)
1.1 Dismount compressor
• Detach hose clip from pressurised air hose.
• Remove pressurised air hose.
• Undo fastening screw of compressor.
• Pull compressor out.
• Branch off the electricity from the compressor's junction plate or disconnect coupling (option) of electrici-
ty from the compressor.
• Take out compressor.
1.2 Disassemble compressor
• Unscrew fan cap 35.
• Loosen connecting nut 37 on L-piece 17 of the cylinder head 19 .
• Undo cylinder head screws 18 .
• Remove cylinder head 19 , suction and pressure valves with seals 20-24 .
• Undo fastening screws of cylinder 25 and remove cylinder from pistons.
1.3 Clean and if necessary replace compressor parts
• Dry clean all parts.
• Replace damaged or worn valves.
• Replace seals for cylinder and cylinder head.
1.4 Assemble compressor
• Fit both piston rings 27 turned 180°!
• Replace backer strip 29 and springs 27 .
• Put on cylinder 25 and screw tightly.
The piston must not project out of the cylinder in the top dead centre position. (check with ruler!)
• Place cylinder head, suction and pressure valves with seals 20-24 on cylinder 25 .
Pay attention to the order of suction and pressure valve platess and marking holes.
• Insert and tighten cylinder head screws 18 . Do not tighten screws too much (10 Nm)!
• Fasten connecting nut 37 on L-piece 17 of the cylinder head 19 .
• Screw on fan cap 35 .
1.5 Change air intake filter (see page 38)
• Turn and pull filter cap to the left.
• Replace filter cartridge
5 .
• Put on filter cap again and tighten.
1.6 Mount compressor
• Place compressor in front of equipment.
• Connect electricity.
• Place compressor into the equipment.
• Turn in and tighten mounting bolts.
• Mount pressurised air hose and tighten with hose clip.