9
A
B
D
C
A. Valve Configuration Button C. Maintenance Button
B. Sold Out Button
D. Locale Change
The manager’s access to the service menu allows
access to the Lighting screen (see page 15), the Sold
Out screen (see page 16), and the Time & Delays
screen (see page 13).
NOTE
13. For manager’s access to the service menu, press and hold
the upper, right-hand corner of the screen for a minimum of
five (5) seconds and enter the manager’s pin number (6655).
This mode prevents users from dispensing drinks and
acts as a power saving tool while the unit is not in
use.
NOTE
A. Purge Tab
B. Up to 4 Purge Buttons Selected
C. ‘Greyed Out’ Purge Button
A
B
C
14. To lock the dispenser, or put it in “sleep” mode, repeat Step
13 but instead enter the lock code (3.14).
Once the purge is activated, it will continue to dispense
product until it is deactivated. To deactivate the purge,
simply press the
Purge
button again. Up to four
modules can be purged at one time. Once four modules
are selected, all other modules are greyed out and
cannot be selected.
NOTE
19. Once a steady flow of water is achieved, press the
Purge
button again to deactivate the modules.
20. Ensure that the pump deck at the remote chiller is turned off
before turning on the CO
2
.
21. Turn on CO
2
at the source then, using a screwdriver, adjust
the high pressure regulator at the source to 65 PSI (0.448
MPa) then tighten locknut with wrench.
A. Regulator Adjustment Screw
B. Adjust to 65 PSI (0.448 MPa)
C. Wrench
A
B
C
22. Purge the carbonated water module until gas-out.
23. Reactivate the pump deck at the remote chiller.
24. Purge the carbonated water module again until a steady flow
of carbonated water is achieved.
25. Purge each syrup module until a steady flow of syrup is
achieved.
15. For access to only the Sold Out Menu, repeat Step 13 and
enter the Sold Out pin (963.).
16. From the service menu press the
Maintenance
button.
17. Press the purge tab on the far left side of the screen.
18. Press the
Purge
buttons for both the plain water and the
carbonated water modules.
