7
Dispenser Installation
1. Using proper lifting techniques, lift the tower over the counter
top, then route end of power cord through the opening in the
counter.
2. Slide the tower into the cutout in the counter and use the
screws and mounting brackets provided to secure the tower
to the counter.
A
B
C
A. Oetiker Pliers
B. Fitting
C. Tubing
D. Syrup/Water
Inlet
D
DO NOT PLUG UNIT INTO GROUNDED ELECTRICAL
OUTLET AT THIS TIME.
Make sure that all water lines are
tight and unit is dry before making any electrical
connections
!
WARNING
When attaching the tower to the counter, make sure
the screws do not extend more than 0.75 in (19 mm)
from the top of the mounting plate. These could
damage the valves when installing the dispenser.
!
ATTENTION
If a drain line is utilized, then connect ADA wire
harness in drip tray to wire harness behind splash
plate before attaching drip tray.
!
ATTENTION
3. Route appropriate tubing from the syrup pump location to the
syrup inlets on the tower. Connect tubing to inlets using the
oetiker pliers and fittings. Repeat for all syrup connections.
4. Route appropriate tubing for the carbonated/plain water
inlets then connect tubing to inlet. Repeat for all water
connections including the return inlet.
5. Slide drip tray into opening in tower until magnets engage
and lock drip tray in place. Connect ADA wire harness from
drip tray to ADA wire harness in tower.
NSF listed units must be sealed to the counter.
NOTE
A
D
E
F
C
B
A. Seal
B. Drip Tray
C. Counter
D. Upper Drain Fitting
E. Lower Drain Fitting
F. Washer
7. Plug in power cord to power supply then route power supply
cord to the designated grounded electrical outlet.
6. If a drain line is to be utilized, place gasket at the bottom of
the drain then attach drain fitting to drip tray.
Unit has the option to be supported by a remote chiller
system or remote ice cooled system. Please see the
manufacturer’s specifications and instructions for
installation. The following are the instructions for
plumbing the remote chiller system to the tower.
NOTE
8. Route appropriate tubing from the syrup pump location to
the syrup inlets at the remote chiller. Repeat for all syrup
connections.
9. Route appropriate tubing from the water source to the water
inlet at the remote chiller and only connect tubing to the
water source.
10. Turn on the water and flush the water line thoroughly.
11. Turn off the water and connect water line to the plain water
inlet at the remote chiller.
A
B
A. Tower
B. Drip Tray
C. Magnet Connection
in Tower
C
A
B
C
A. Tower
B. Syrup/Water Inlets
C. Mounting Brackets
(Underneath Counter)
D. Connection Screws
(Underneath Counter)
D
C
