Lancellotti MAESTRO, Инструкции для пользователя

Страница: 332 / 408

Instructions for the installer
332
3.1 General warnings
The following operations must be carried out by a qualified installing technician. The
installing technician is responsible for correctly installing the appliance according to
current safety standards.
Before using the appliance, remove the protective plastic on the control
panel, stainless steel parts, etc...
The manufacturer declines any responsibility for damage incurred by persons, animals or
objects that is caused by not following the above guidelines (cfr. chapter “
2. Warnings for
safety and use”).
The technical data is indicated on the plate located on the back of the appliance. The adjustment
conditions are shown on a label applied to the packing and the appliance.
Do not use the oven door handle for lifting or handling, including while
unpacking the appliance.
3.2 Replacing the adjustable feet
The cooker comes with
standard
feet, already installed.
The standard feet allow you to adjust the height so that you can level the cooker to the floor; the
cooker becomes unstable if you unscrew them too much.
To raise the cooker, you should replace the
standard
feet with higher ones (supplied with some
models or ordered from your retailer) for an extra
3 cm
but, should this not be enough for your
requirements, you can add another kit from your retailer to raise it even more.
Before turning the cooker over, we recommend removing all the parts that are not stably attached
to it, in particular the cooking hob grids and burners. To lighten the weight of the cooker, the
accessories inside the oven may also be removed, thereby preventing accidental damage during
the overturning operation.
Proceed in either of the following ways to
replace the feet:
A
Lifting the cooker off the floor.
B
Laying the cooker on its back.
Remove the feet from the packing and
screw them to the bottom of the cooker.
Make the
final adjustment
of the feet, to
level the cooker to the floor,
after
completing the gas and electrical
connections
.
Should you need to drag the equipment, tighten the feet all the way and then adjust them after
placing it where expected.