47
SPECIAL PROGRAMS
25.5
•
SOLID CAL DESCALER CREATION
When calling up the washing procedure,
if the lower display shows the flashing
message
[SCA]
, the creation of the
SOLID
CAL
descaler must be performed.
Proceed as follows:
Select the wash and press
START/STOP
.
The heating/cooling procedure for the oven
chamber is performed.
Follow the instructions on the lower display:
[FC1]
Remove the cap from the
SOLID CAL
drawer
[FC2]
Insert the
SOLID CAL
container and press
the
START/STOP
key
[FC3]
Waiting water loading in progress
[FC4]
Waiting recirculation in progress
[FC5]
Remove the
SOLID CAL
container
[FC6]
Did the container empty?
Select “Yes”
[Y]
pressing the “core probe”
key or “No”
[n]
pressing the “Fast Dry” key
twice.
[FC7]
Thoroughly clean the cap housing and the
cap and replace the cap.
If there is an error in the descaler creation
procedure, the error message
[Err]
appears on the upper display and the
procedure is interrupted. Press
START/
STOP
to restart the procedure.
If the error persists, note the error code
and contact customer service.
NOTE:
The wash is done as needed
between phases
[FC2]
and
[FC5]
.
When washing is complete, the displays
show the procedure has ended (example:
[HPC] [End]
).
25
•
WASH KIT
SOLID DETERGENTS
90028111rev03
