14
OPERATIONS
5.1
•
SWITCH ON
Press button 15 for 3 seconds.
Whenever
a symbol appears in the anomalies display
(display
7-9
) see the
“Selfdiagnosis and
anomalies key”
chapter.
Note:
cooking in manual mode with
several phases in sequence allows the
pre-heating of the empty cooking chamber
before cooking: just set the cycle time 1
at
infinite [ InF ]
. On reaching the pre-
heat temperature, a cyclic acoustic signal
and
[ LoA ]
on the display inform that is
time to use the oven. When the door is
closed, the Cycles button
1
displays the
second LED (2) flashing, which indicates
activation of the cooking cycle 2.
5.2
•
SELECT
The cooking mode buttons LEDs flash:
press the button of the desired cooking
mode (2 - 3 - 4).
The selected cooking
mode LED will remain on with a fixed light.
5.3
•
SET THE TEMPERATURE OF
CYCLE 1
Tur ning knob 8 sets the cooking
temperature
, which is shown on the
relevant display.
5.4A
•
SET THE TIME FOR CYCLE 1
The time display shows
[ InF ]
.
Turn knob 10
:
to the right to set the cooking time;
to the left to set infinite time,
[ InF ]
thus
utilizing the
first cycle as preheating.
Or
5.4B
•
SET THE CORE PROBE
FOR CYCLE 1
Refer to
“Setting the core probe”
.
5.5
•
SELECT CYCLE 2 AND THE
FOLLOWING ONES
(UP TO 4 CYCLES)
Press the cycles button
1
, the second
flashing LED (2) switches-on on the
cycles button. Proceed with setting as per
paragraph 5.2. If other phases are desired,
follow the same sequence.
5.6 • SETTING A NEW COOKING
If you wish to program a new cooking, the
previous cooking must be reset by pressing
button
1
for 3 seconds, after which the
cooking mode LEDs flash to indicate it has
been reset.
5.7 • SAVING THE COOKING MODE
If you wish to save the cooking, press knob
10
for 3 seconds.
The first free program will appear on display
7
, select the desired program number by
turning knob
8
and confirm by pressing
knob
8
.
5
•
MANUAL SETTINGS FOR COOKING
WITH UP TO 4 CYCLES IN SEQUENCE
90028111rev03