
Page 51 of 60
2
POWER
CONNECTIONS
Before connecting from the starter to the power source, be sure that the voltage is the same as the
electrical system supplied with the machine.
Press "RUN” key and press the” UP” and/or “DOWN” button to check for proper direction. If the
motion is backwards, change it by re-connecting supply line(s) for proper direction.
3
HOW TO SET UP THE NEW VALUE:
3.1 Press the "EDIT" key. The column of SETTING VALUE will flash the L.E.D. when it is under EDIT
mode.
3.2 Select the desired setting group of MODEL / STEP.
a. The range of the setting group-MODEL is from 0 to 99 groups. Press the “MODEL" key. The column
of MODEL will flash. Enter the desired number or use the "NEXT" key to search the group and press
"ENT". Then, the group-MODEL setting has been completed and the flashing will stop.
The number at the SETTING VALUE will flash.
b. The range of the setting section is from 1 to 9 sections. Press the “STEP" key. The digit in this column
will flash. Follow the directions above and the section setting is complete.
The number at the SETTING VALUE will flash.
c. The range of the position setting depends on the spindle travel. Key-in the desired spindle height
setting and press "ENTER."
3-27
Содержание S45T
