laguna S45T, Руководство пользователя, Страница: 34 / 80

Page 34 of 60
FOR 3-SPEED SPINDLE MOULDER
1. Loosen handwheel lock (a) Fig. 3.20, before making adjustment of
spindle height.
2. To raise the spindle, turn handwheel (B) clockwise and lower the
spindle, turn handwheel (B) counterclockwise.
3. Tighten handwheel lock (A) when desired spindle height is
obtained.
4.
One complete turn of the handwheel moves the spindle up or
down by 2mm.
Fig. 3.20
《
WARNIN
G
》
Final height setting of the cutter should always be from the bottom to the up position.
3.7 SPINDLE TILTING ADJUSTMENT
Stop the machine before tilting the spindle. Unlock the spindle. Be sure that the cutter does not touch the table
and the fences.
FOR 5-SPEED SPINDLE MOULDER
Forward tilt type
The dial indicator of tilting degree indicates the figures from -5 or -10
to 45 degree. When adjust the tilt of spindle:
1.
Replace the table rings and install the one for use with tilting
spindle.
2. Loose the knob (B) Fig. 3.21 on the handwheel (A).
3. Loose the two locking handles (C) on the both sides of machine.
4. Turn the handwheel (A) to the required tilting degree and position.
5. Tighten the knob (B) and locking handles (C).
Digital read-out for spindle tilting degree is available for some specific models.
Fig.3.21
Backward tilt type
The dial indicator of tilting degree indicates the figures from 10 to -45
degree. When adjust the tilt of spindle:
1. Replace the table rings and install the one for use with tilting
spindle.
2. Loose the knob (C) Fig. 3.21.1 on the handwheel (B).
Fig. 3.21.1
3-10