laguna S45T, Руководство пользователя, Страница: 41 / 80

Page 41 of 60
3-16
3.12 SLIDING TABLE ADJUSTMENT
(For sliding table only)
There are six adjustable eccentric rollers (A) Fig.3.40, on sliding
table. Wherever the table is unstable or not traveling in line, adjust
the sliding table as follow:
1. Use open end wrench (B) to adjust the rollers.
2. Lock the rollers by using the hex. Wrench (C)
SLIDING TABLE LOCK
To operate the sliding table (G) Fig.3.40, pull out and rotate knob
(D) until it stays in the out position as shown. The sliding table
can then be moved back and forth. To lock the sliding table,
preventing it from moving, simply rotate knob (D), until knob (D)
moves to the up position and the pin on the other end of the knob
engages a hole underneath the table.
Fig. 3.40
3.13 EXTENSION SUPPORT ADJUSTMENT
(For extension table only)
1. Loosen the two locking knobs (A) Fig.3.41 to loosen the
extension bars.
2. Pull the extension support to the desired position
3. Tighten the two locking knobs to lock it.
Fig. 3.41
3.14 TENONING CARRIAGE
(optional)
IN UP POSITION FOR TENONING WORK
The 2-position tenoning carriage shall be used with tenoning hood
and clamp attachment to ensure the safety and stability during
operations. To operate the tenoning carriage, proceed as follows:
1. Push downwanrd the handle (A) Fig.3.42, to raise the table
support (B) and tenoning table (C), than rotate the knob (D)
until it moves to the right position.
2. Loosen the two locking levers (E) and slide the tenoning table
(C) to the desired position. For accurate shaping with minimal
vibration, the tenoning table should run close to he spindle.
3. Tighten two locking levers (E).
Fig. 3.42