laguna S45T, Руководство пользователя, Страница: 35 / 80

Page 35 of 60
3. Loose the locking handles (D) on the right side of machine.
4. Turn the handwheel (B) to the required tilting degree and position.
A dial indicator showing existing tilting degree is provided for your convenient adjustment.
5. Tighten the knob (C) and locking handles (D).
FOR 3-SPEED SPINDLE MOULDER
The scale of tilting degree indicates the figures from -5 to 30 degree. When adjust the tilt of spindle:
1. Replace the table rings and install the one for use with tilting spindle.
2. Loose the knob (C) Fig. 3.20.
3. Turn the knob (D) to the required tilting degree and position.
4. Tighten the knob (C).
3.8 ASSEMBLING CUTTERS TO SPINDLE
Before changing the tool, the electricity power should be shut off.
1. Disconnect the machine from the power source and engage the spindle
lock as explained in the section “SPINDLE LOCK”.
2. Place the cutter (A) Fig. 3.22, and desired spindle rings (B) on the spindle
as shown.
3. Tighten nut (D) using the wrench supplied and disengage spindle lock.
Or tighten safety nut w/washer (E) using the wrench supplied and disengages
spindle lock.
Fig.3.22
《
WARNIN
G
》
Whenever possible, the cutter should be position on the spindle in such a way that the cut us
being performed from under the surface of the workpiece.
《
WARNIN
G
》
Always place the “keyed” washer (C) Fig. 3.22, on spindle before threading on nut (D).The
“keyed” washer (C) prevents the nut (D), from loosening when spindle turns
counterclockwise.
《
WARNIN
G
》
After installing and replacing cutter please check one more time carefully. Be sure that the
direction of cutter is correct and the keyed washer, spindle rings are directly under spindle nut
and spindle nut is tightened securely.
3.9 TABLE RINGS
A set of table rings is supplied with your machine and can be removed individually for use with various size
cutters.
A table ring for use with tilting spindle is also available.
3-11