
Page 42 of 60
3-17
IN DOWN POSITION AS EXTENSION TABLE
The tenoning carriage can be lowered to be at the same level of the machine table and used as an extension
table for the machine of long workpiece.
1. Loosen the two locking levers (E), and slide the tenoning table
(C) just away from machine table.
2. Slightly push downward the handle (A) to pull out and rotate
the knob (D) until it stays in the out position, then guide the
handle (A) to the top position, the tenoning table can be
lowered.
3. Slide the tenoning carriage to the proper position on the rail.
4. Tighten locking lever (F) against the nearest screw head on the
rail to prevent the tenoning carriage from moving.
Fig. 3.42.1
3.15 INSTALLING TENONING HOOD
(optional)
1. Lean the hood on the table, regulate the distance from the cutters
and secure the position by tightening the locking levers (A)
Fig.3.43, Fig.3.44.
2. Regulate the height of the protection in respect of the cutters by
turning the knobs (B)
3. Fences (C) Fig 3-44 shall always be used for tenoning work
cutting to provide adequate guiding workpiece.
Fig. 3.43
《
WARNING
》
The machine should be equipped with the tenoning
hood when doing tenoning work.
Fig. 3.44
Содержание S45T
