
Page 46 of 60
AUTOMATIC OPERATION
1.
Install cutter(s) on spindle. For this example three cutters are used and three height settings-one for each
cutter.
2.
In manual mode adjust spindle height to proper setting for cutter “A”, as shown in Fig.3.47. Set
reference point for setting no.1.
3.
Setting no.2 for cutter “B” in the same manner, as shown in Fig.3.48. Repeat for other cutters if needed.
4.
For last setting in cycle (in this example we have 3 settings) set to zero setting point as shown in
Fig.3.49-this indicates end of cycle and next setting will be no.1 again.
Fig. 3.47 Fig. 3.48 Fig. 3.49
WARNING SIGNAL
1.
“00”: Emergency stop button not reset or cabinet door is not perfectly closed.
2.
“01”: Spindle motor has been overloaded and tripped thermal overload protector in magnetic
starter-needs reset.
3.
“02”: Spindle height is too height tripping limit switch at end of travel.
4.
“03”: Spindle height is too low tripping limit switch at end of travel.
5.
“04”: Spindle lifting motor (up & down) has been overloaded and tripped thermal overload protector in
magnetic starter-needs reset.
6.
“05”:
Pneumatic cylinder (sensor 1) is not located in the correct position.
-Make sure the notch on the tool holder, is engaged with tang on the shaft.
7.
Draw bar (sensor2) is not located in the correct position.
'-Make sure the notch on the tool holder, is engaged with tang on the shaft.
PRESETTING PARAMETER
Parameter Description Unit
Preset value by
manufacturer
Recommended value
1.
Locking time for shaft sleeve
0.01sec
0
0
2.
Pre-setting time for spindle up
0.1mm
6
5-8
3.
Pre-setting time for spindle down
0.1mm
15
10-20
4.
Spindle lifting motor running time for
positioning
0.01sec
3 2-4
5.
Spindle lifting motor intermission
time for positioning
0.01sec
15 10-25
6. Encoder
reset
0.1mm
0
-------
3-22
Содержание S45T
