laguna S45T, Руководство пользователя, Страница: 45 / 80

Page 45 of 60
M.
Param/now key-used to set/check up to 10 different spindle height setting and zero reference points(s).
N.
Next key-each time next key is depressed digital readout advances to next parameter (setting).
O.
Negative signal
P.
Edit/run key-used to charge “EDIT” or “RUN” mode. Flashing L.E.D. indicates “EDIT” mode.
Q.
Number-key (0~9).
R.
Clear key- used to remove value and negative signal currently on digital display.
S.
Enter key
T.
Spindle height
U.
Spindle height position
POWER CONNECTIONS
Before connecting from the starter to the power source, be sure that the voltage is of the same
characteristics as the electrical system supplied with your machine. “EDIT/RUN” key should be on “RUN”
(with no flashing L.E.D.).
Depress “UP” and/or “DOWN” key to check for proper direction. If motion is backwards change by
re-connecting supply line(s) for proper direction.
ENTER A NEW SPINDLE HEIGHT SETTING
1. “EDIT/RUN” key should be set on “EDIT” (flashing L.E.D.).
2. Key-in desired spindle height setting on position “1” then depress “ENTER” key. The first preset is
now set.
3. Follow steps 1 and 2 to enter additional presents.
4. After all setting are made depress “EDIT/RUN” key till set on ”RUN” mode (with no flashing L.E.D.).
From this point on each time the “Enter” key on the control panel is depressed the spindle height setting
will advance one setting.
CHECKING SETTINGS ALREADY SET-UP IN SYSYEM
1. “DEIT/RUN” key should be set on “RUN” (with no flashing L.E.D).
2. Depress the “PARAM/NOW” key to view digital readout of current spindle height setting.
3. Depress the” NEXT” key to view digital readout all other settings currently in the system.
SETTING ZERO REFERENCE POINT
1. “EDIT/RUN” key should be set on “EDIT’ (flashing L.E.D.).
2. “PARAM/NOW” key should be set on “PARAM” (comma, showing on display).
3. Depress “NEXT” key, then “O” key, then “ENTER” key to set zero reference. Point.
3-21