laguna S45T, Руководство пользователя, Страница: 32 / 80

Page 32 of 60
5. Very carefully insert the draw bar (B) and spindle (A) Fig.3.12,
down through the shaft as shown. Make sure the tang (C), on the
spindle, is engaged with the notch (D), and thread spindle nut (E)
onto threads (F).
6. Engage spindle lock as explained in the section “SPINDLE
LOCK”.
7. Using the special spanner wrench (G) Fig.3.13
tighten spindle nut (E) as shown.
Fig. 3.13
8. Open the cabinet door and assemble the special level washer (H) to
the bottom of the draw bar (B), as shown in Fig.3.14. The bevel
washer (H) was removed from the draw bar in STEP 4.
9. Assemble and securely tighten the two lock nuts (I) Fig. 3.14 as
shown. The two lock nuts (I) were removed from the draw bar (B)
in STEP 4.
10. Disengage the spindle lock.
Fig. 3.14
FOR INTERCHANGEABLE SPINDLE WITHOUT DRAW BAR
1. Disconnect the machine from the power source and remove the
table rings.
2. Turn the spindle raising and lowering handwheel and raise the
main shaft all the way to the top.
3. Engage spindle lock as explained in the section “SPINDLE
LOCK”.
4. The taper of the interchangeable spindle and the internal taper of
the shaft must be cleaned thoroughly using a cloth moistened with
kerosene or mineral spirits. Do not use gasoline or lacquer thinner
for this purpose.
Fig.3.15
5. Very carefully insert the spindle (A) Fig.3.15 to the hole of main shaft. Make sure the tang (B) on the
spindle is engaged with the notch, then lock it with nut (C) , and lock nut (D) in reverse direction.
6. At the upper part of the lock nut (D) there are two screws (E). Turn the two screws (E) by pressing the
threads of the nuts (D) tightly in order to prevent the spindle from loosening when it is used in the forward
and reverse directions.
To take off spindle:
1. Before lock nut (D) is loosened, two screws (E) must be loosened first.
2. The lock nut (D) can not be taken away alone. Only loosen the lock nut by turning twice only, then loosen
the nut (C) until the spindle is taken off.
3-8