laguna S45T, Руководство пользователя, Страница: 30 / 80

Page 30 of 60
For 3-SPEED SPINDLE MOULDER
The 3-speed spindle moulder is supplied with a 3-step motor pulley and a 3-step spindle pulley that provides
spindle speeds of 5500, 7500 and 10000 RPM.
A speed chart Fig.3.7 is located in the front of the machine for easy reference of the belt position on the
pulleys for three speeds available. To change speeds, proceed as follows:
1. Shut off the power and open the cabinet door.
《
NOTE
》
A limit switch is provided which prevents the machine from being turned on when the cabinet door
is in the open position.
2. Loosen lock lever (A) Fig.3.8, then move tension lever (B), to the left to loosen belt tension.
The belt (C) can then be moved to the desired steps of the motor pulley (D) and spindle pulley (E).
3. After the belt is positioned on the desired steps of the motor pulley and spindle pulley, move tension lever
(B) to the right to apply belt tension and tighten lock lever (A).
Fig. 3.7 Fig. 3.8
3.4 Spindle lock
A spindle lock is provided with your machine in on of the following
types to assist you when changing spindle or installing and removing
cutters.
《
CAUTION
》
Spindle lock is provided with your machine in one of
the following types to assist you when changing
spindle or installing and removing cutters.
Fig. 3.9
BASIC TYPE
1. Open rear cover of the machine. Rotate lock knob (A) Fig. 3.9, until the hole on the knob engages the pin
on the other end of the knob. The knob (A) will then be latched in “lock spindle”.
2. Close rear door.
3-6