
Page 10 of 60
1-6
3) for workpiece guiding the use of:
i) a fence.
ii) a false fence wherever possible to minim is the gap between the cutter(s) and the fence plates.
iii) a push block or push stick to aid hand feeding or wherever possible a de-mountable power feed unit.
iv) roller or extension table to support long workpiece.
4) before machine to:
i) fit the tooling to the machine to operate in the correct direction of rotation and feed the workpiece to
the tools against the direction of the spindle.
ii) ensure that the selected rotational speed is appropriate for the tooling being used.
iii) select and adjust the guard.
iv) because of the wide variety of work which can be undertaken on vertical spindle moulding machine
no one type of safeguard can be considered effective for all conditions. Each operation should be
considered separately and the best practicable safeguard selected. The type of tool, cutting edge
projection and the height at which the tool is set, will determine the minimum size of the hole in the
table.
1) for straight work: in order to prevent access to the tool during straight work it is necessary to use in
conjunction with the fence either a de-mountable power feed unit or fence and table pressure pads
equipped with special shoes depending upon the workpiece dimension.
2) stopped work: in order prevent access to the tool during stopped work it is necessary to use in
conjunction with the fence, table and fence pressure pad equipped with special shoes depending upon
the workpiece dimension.
3) in order to prevent kickback it is necessary to use back and/or front end stops fixed to the fence, table
or fixed to an extension table.
4) unless the workpiece is large enough to provide a safe and adequate hand hold, the use of a jig is
recommended.
5) for curved work: in addition to the use of a guiding steady(lead in device) and in conjunction with the
adjustable guard (hand protector) a template is useful to prevent access to the tool.
6) for bevel cutting: in addition to the use of the fence and de-mountable power feed unit or pressure pads,
it is important to ensure firm support of the workpiece by using a special jig or adjustable canting
fence in order to prevent access to the tool.
7) for tenoning: in order to feed the workpiece safely passed the tool during tenoning it is necessary to
use the traveling table and enclosure provided by the manufacturer.
5) Waste and Disposal
Please concentrate the waste chip and dispose them in accord with the EU legislation and policies.
Before dismantling the machine, disconnect all energy sources carefully.
(1) Dismantling of Electrical Systems
Before disconnect the cables from the power cabinet, please confirm first that all switches have been
closed.
Содержание S45T
