Laguna Tools CNC Swift Series, Руководство пользователя

Страница: 8 / 55

LAGUNA TOOLS 8
7. Water pump ‐ The water pump provides coolant for the router spindle motor. Running the router
spindle without the cooling pump running can lead to spindle bearing failure.
PC COMPONENTS

There are circuit boards that have been installed into the
PC's tower. If the PC is to be replaced the cards must be
re ‐ installed into the new PC tower. The WinCNC software
must then be re ‐ installed.
ASSEMBLY AND SETUP
WHERE TO LOCATE YOUR MACHINE
Before you unpack your machine, select the area where you will use your machine. There are no hard and fast
rules for its location, but, here are a few guidelines.

There should be an area around the machine suitable for the length of wood that you will be
machining.

Adequate lighting. The better the lighting, the more accurate and safely you will be able to work.

Solid floor. You should select a solid flat floor, preferably made of concrete or something similar.

Close to power source and dust collection.
UNPACKING THE MACHINE
1. To unpack your machine, you will need tin snips, a knife and a wrench.
2. Using the tin snips, cut the banding that is securing the machine to the pallet [if fitted].
WARNING: EXTREME CAUTION MUST BE USED BECAUSE
THE BANDING WILL SPRING AND COULD CAUSE INJURY.
3. Remove the box from the CNC machine if fitted and any other packaging material. The parts
ordered with the machine will be packed on or inside the machine. Note. The machine is heavy,
and if you have any doubt about the described procedure, seek professional assistance. Do not
attempt any procedure that you feel is unsafe, or that you do not have the physical capability of
achieving.
4. Use a fork lift with sufficient lifting capacity and forks that are long enough to reach the complete
width of the machine.
5. Remove the securing bolts that attach the machine to the pallet [if fitted].
Figure 2. PC Tower showing internal PCI cards