LAGUNA
TOOLS
40
L
‐
CODES
L1
Save Positions - L1 N# V#
Store values is the saved positions file. Can store a value in one of the 30 existing ‘H’ registers.
N# is the desired ‘H’ register number, can be 0 to 29.
V# is the desired value. Can be the result of a math operation or a constant.
L1.1
Save ‘H’ Register
Save the ‘H’ register value to a file.
L1.2
Load ‘H’ Register
Load the ‘H’ register value from a file.
L3
Set Home Position - L3 XYZW
Stores current position of each axis specified. Values specified are ignored.
L4
Return to Home
Moves each axis specified to the last L3 position stored. Values specified are ignored.
L5
Set Contouring Velocity - L5 XYZ
Sets the contouring velocity in units per minute.
L6
Set Acceleration - L6 XYZ
Sets the acceleration in units per minute per second. L6 alone restores the original values.
L7
Set Acceleration Percentage L7 P#
Sets the acceleration to a percentage of the current acceleration. P# is the percentage (1-100) to set. L7
alone restores the original.
L8
Turns Backlash Compensation On, Restore INI values for all axes.
Examples:
L8XY - Turn Backlash Compensation On, Restore INI values
for specified axes.
L8X.001 - Turns Backlash Compensation On, Set new value
for specified axis.
L9
Turns Backlash Compensation Off.
L10
Cut Array - L10 R# C# X# Y# E#
Sets up array cutting. Repeats all code following until the end of the file or another L10 is reached. Program
pointer is moved back to initial L10. The head is moved to the next column or row specified by XY at rapid
velocity. Cycle repeats until all array points have been cut. L10 specified without RCXY values can be used to
end an array cut. Lines that follow will not be repeated. If an ‘E’ is found on the L10 command line then
WinCNC will skip the final move back to the starting position at the end of the array. If no ‘E’ is found then
WinCNC will move back to the starting position at the end of the array.
Содержание CNC Swift Series
Страница 54: ...LAGUNA TOOLS 54 SPECIFICATIONS...