Laguna Tools CNC Swift Series, Руководство пользователя

Страница: 42 / 55

LAGUNA TOOLS 42
WINCNC.INI defaults.
L23.1
Restore High Boundaries - L23.1 XYZW
Restores default High boundaries to the specified axes.
L28 Set Position - L28 X# Y# Z# W#
Sets Machine Coordinates. Machine Coordinates specify the fixed machine zero point for your machine. L28
is normally used only to write a custom homing program. L28 does not move the machine, but sets the
current position to the values specified. Use G92 to set a local coordinate system for running absolute mode
programs from any table position.
L29 Clear Home Flags - L29 XYZ
Clears all require home flags. Axes can be used with the command to clear require home flags only on the
specified axes.
L29.1 Ignore Home Flags
Ignores require home flags for all axes during execution of the currently running file.
L30
Knife Mode On
Enables support for the Knife Mode.
L30.1 Knife Parameters L30.1 A# Z# P#
Set Lift Angle, Lift Position, and Plunge depth for knife. When amount of change in the angle of the knife
exceeds A# the knife will lift to make the turn. A# is also used for angle correction in Target Mode: see
Knifemode =. Z# is the position to lift to. P# is the position that the knife will plunge to.
L31 Knife Mode Off
Disables support for the Knife Mode.
L32
Saw Mode On
Enables support for the Saw Mode.
L33 Saw Mode Off
Disables support for the Saw Mode.
L34 AutoAuxOut Enable - L34 D#
Enables an auxiliary output that will turn on during G1/G2/G3 moves, and will turn off for all other moves. L34
D# sets the dwell time in seconds used when the channel is set to on and L35 D# sets the dwell time in
seconds when the channel is set to off. When the ‘D’ parameter is used with the L34 command the “Au-
toAuxOut” mode does not change. L34 parameters are set in the WINCNC.INI file by the “autoaux=” line.
L35 AutoAuxOut Disable - L35 D#
Disables the auxiliary output that is turned on by the L34 command. L35 D# sets the dwell time in seconds
when the channel is set to off. When the ‘D’ parameter is used with the L35 command the “AutoAuxOut”
mode does not change.
L36 Torch Height Control On.