English
20 EN
Counters are displayed by pressing the
(
27
) key.
The following message appears on the display (
5
):
À
COUNTERS MENU
N
° coffee gr. 1
01234
N
° coffee gr. 2
01234
N
° coffee gr. 3
01234
N
° water
01234
N
° steam
01234
+
Parameters calculated are:
-
N. coffee
(number of coffee beverages)
-
N. water
(number of times water is dispensed)
-
N. steam
(number of times steam is dispensed using
the steam button)
-
N. steam air TS
(number of times steam and air are
dispensed using the turbosteam function)
-
N. tot coffee
(total number of coffee beverages).
Counters can be zeroed by aligning the cursor on the selected
entry, pressing the
key (
29
), and then pressing the
(
30
) or
(
31
) key.
Press the
key (
24
WRFRQ¿UP]HURLQJ
The "N. coffee" entry appears for as many times as there
are machine groups.
Note: Parameters that cannot be zeroed are:
- N. tot coffee
Press the
key (
24
) to return to the main menu.
N.B. ONLY if the item “Customer Progr.” is set on “YES"
and the item “Program. block” is set on “NO".
To access programming press the
key (
29
); the following
message will appear on the display:
À
CUSTOMER PROG.
KEY MENU
Press one of the dispensing keys on the selection panel (
2
);
the relative led will remain on.
Use the
(
30
) and
(
31
) keys to position the cursor
(black line) on the desired line, then press the
key (
29
).
Always use the
(
30
) and
(
31
) keys to change the
setting; at this point there are two possibilities:
FRQ¿UPWKHFKDQJHVPDGHE\SUHVVLQJWKH
key
2) exit the menu and leave the settings unchanged by
pressing the
key (
24
).
Note: When modifying data, the cursor changes to "
Æ
", or a slide bar with maximum and minimum
settings will appear:
-5 064 +5
-
+
If the "
Customer Progr.
" is set to "NO", the following
message will appear on the display:
ÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀ
CUSTOMER PROG.
NOT ENABLED!
ÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀÀ
21. DATA menu - Counter display and zeroing
22. How to access the programming mode
