54-0208-01
2.6
TracVision A5 Installation Guide
6.
With the cushions installed in the brackets, the
bottom of the antenna should rest higher than 1"
above the vehicle’s roof. If the antenna’s base is
less than 1" from the roof, you will need to add a
spacer under each bracket to raise the antenna
higher off the crossbars.
If spacers are needed, follow the steps below to
install a spacer under each bracket:
a.
Remove the #8-32 x
3
⁄
8
" screws and washers
securing the factory-installed plastic spacer to
the metal bracket.
b. Insert a second spacer from the kitpack
between the original spacer
(which holds the
rubber cushions)
and the bracket. Secure both
spacers to the bracket using the #8-32 x 1"
screws supplied in the kitpack and the
original washers that you removed in Step a.
Bracket
New Spacer
Flat Washer
Lock Washer
#8-32 x 1" Screw
Factory-installed
Spacer
Adding a Second Spacer to the Bracket (If Needed)
If, after installing the additional spacers,
there is still less than 1" of space between
the antenna and the roof, KVH recommends
that you attach a wide (at least 7" diameter)
section of rubber, neoprene, or foam to the
center of the antenna’s base to protect the
roof.
Содержание TracVision A5
Страница 1: ......
