KVH Industries TracVision A5, Руководство по установке

Страница: 11 / 78

3-1 Wiring the Receiver
The receiver rear panel has been modified to accept the new RF
converter cable. The diagram below shows the new receiver
wiring.
Connecting the RF Converter Cable
To connect the RF converter cable, follow the steps below.
1. Connect the RF converter cable to the “RF Remote
Input” jack on the receiver’s rear panel.
2. Place the RF converter at least three feet away
from the receiver’s location.
Connecting an Existing IR Input (Optional)
The optional vehicle IR adapter cable is no longer available. Use
the new RF converter in all installations.
4
TracVision A5 Wiring Diagram
Antenna
For detailed system wiring
instructions, refer to the
TracVision A5 Installation Guide
.
RF Converter
Receiver
Vehicle Roof
C AU T I O N
KVH® is a registered trademark of KVH Industries, Inc. HUGHES™ is a trademark of Hughes Electronics Corporation.
This device complies with Part 15J of the FCC rules. Operation is subject to the following two conditions:
(1) This device must not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Product Warranty void if outer casing removed.
VEHICLE POWER
(10-16 VDC)
VHF
ANTENNA IN
S-VIDEO
TO KVH
ANTENNA
TO VIDEO
TruSurround, SRS and symbol are trademarks of SRS Labs, Inc.
SATELLITE IN
AUDIO R AUDIO L VIDEO
Service/
Maintenance
Only
DC Power
Ground
To Vehicle
Audio
To Vehicle Video
(Option 1) To Vehicle Video
(Option 1)
To Vehicle Video
(Option 3)
To Vehicle Video
(Option 2)
To VHF Antenna
(Optional)
Vehicle Power
(10-16 VDC)
Fuse
RF REMOTE
INPUT
OUT TO TV
COMPOSITE VIDEO
TO IRD
SATELLITE IN
DIAGNOSTIC PORT 1 DIAGNOSTIC PORT 2
The RF converter must be placed at least three feet away
from the receiver. Placing the RF converter closer to the
receiver may result in interference, causing the remote
control to operate intermittently or not at all.