54-0208-01
3.6
TracVision A5 Installation Guide
5.
Insert the antenna cable into the
tool. Be sure to insert the cable in
the correct side, as noted on the
tool. Let the blade clamp down
on the cable.
6.
The cable should
extend just slightly
beyond the tool body.
Twist the tool around
the cable for 3 or 4
complete turns.
7.
Hold the cable while pulling the tool so that it
strips off the cable jacket. The end of the cable
should now look like the figure below.
8.
Fold the braid over the cable jacket, then slide the
connector body onto the prepared cable and slide
the compression fitting up into the connector
body. Put the Snap-N-Seal ring up the cable, wide
end first, then push the connector onto the cable
until the foam is even with the bottom of the
inside of the connector’s threaded end. The body
of the connector should easily push up under the
foil and braid of the cable.
9.
Move the handle away
from the tool and put the
cable with the connector
in the tool cavity. Be sure
the cable’s center
conductor is straight.
0.25"
0.25"
Sight Hole
Содержание TracVision A5
Страница 1: ......
