KUHN PRIMOR, Инструкция по эксплуатации

Страница: 32 / 54

32
UNIVERSAL DRIVE
- At maximum extension, there must be a tube overlap of A = 330 mm (Fig. 4).
- At maximum overlap (with the drive shaft compressed), there must be a safety gap of B = 20 mm to
prevent the tubes striking the jaws (Fig. 4).
- If the above conditions are not met, shorten the guards (1) and the tubes (2) by the same length (X)
(Fig. 5).
- Round off and clean the tubes and grease the inside of the outer tube.
- Always make sure that the universal drive shafts are properly fitted and secured.
- Any damaged PTO and universal drive shaft guards must be replaced immediately.
Make sure that the drive guards are properly fitted and prevented from rotat-
ing by the special chains. Replace any damaged guards immediately.
Consult the operating and maintenance instructions enclosed with the drive
shaft.
Fig. 4 Fig. 5