KUHN PRIMOR, Инструкция по эксплуатации

Страница: 10 / 54

10
ELECTRICAL CIRCUIT
Before connecting up the machine’s electrical circuit:
- check the state of the electrical circuit (harnesses, fuses and lighting);
- check the state and cleanness of the power socket.
TYRES
1. Before carrying out any operations on the tyres, make sure the trailer is perfectly stable and
cannot move accidentally (fit chocks).
2. Wheels and tyres must only be fitted, removed and repaired by persons with the expertise required
to do so and possessing the appropriate regulatory tools.
3. Check tyre pressure regularly. Inflate to the pressure indicated by the manufacturer.
4. Check wheel nut tightness regularly.
SERVICING
1. BEFORE CARRYING OUT ANY MAINTENANCE, SERVICING OR REPAIR WORK OR WHEN
INVESTIGATING THE CAUSE OF A FAILURE OR MALFUNCTION, THE PTO
MUST BE
DISENGAGED, THE ENGINE SWITCHED OFF, THE IGNITION KEY REMOVED AND THE
MACHINE RESTING ON THE GROUND.
2. Check regularly that screws and nuts are tight. Tighten if necessary.
3. Before proceeding with any maintenance work on a machine in the raised position, prop up the
machine with an appropriate support.
4. WHEN CLEARING A BLOCKAGE OR REPLACING A WORKING PART, WEAR PROTECTIVE
GLOVES AND ONLY USE APPROPRIATE TOOLS.
5. To avoid environmental contamination, it is forbidden to throw away or dump any type of oil, grease
or filter. Hand them over to specialist recovery firms.
6. Before carrying out any operations on the electrical circuit, disconnect the power source.
7. Any protective devices liable to wear should be checked regularly. Replace them immediately if
they are damaged.
8. Spare parts must comply with the standards and specifications laid down by the manufacturer.
Only use KUHN original spare parts.
9. Before carrying out any electrical welding work on the tractor or towed machine, disconnect the
cables from the alternator and battery.
10. Repairs affecting components under tension or pressure (springs, pressure accumulators, etc.)
require appropriate skills and regulatory tools. They must therefore only be carried out by qualified
personnel.