KUHN PRIMOR, Инструкция по эксплуатации

Страница: 7 / 54

7
18. Never leave the driver’s position while the tractor is running.
19. You should always adapt your speed and driving to the track, road or land. Avoid sudden changes
of direction in all circumstances.
20. Beware! Before operating the loading device (gate) and raising the body, make sure that there can
be no accidental contact with a power line.
21. Beware! Never stand by the delivery chute while the machine is in operation.
22. If cut or injured on contact with the products contained in the machine, disinfect immediately in
order to avoid risks of infection.
23. Steering accuracy, tractor adhesion, roadholding and effective braking are affected by factors
such as the weight and nature of the towed machine, ballasting of the front axle and state of the
land or road. It is therefore essential to apply the degree of care appropriate to each particular
situation.
24. Be extra careful in bends and remember to take account of the overhang, length, height and
weight of the machine.
25. Before using the machine, make sure that the guards are fitted and in good conditions.
Damaged guards must be replaced immediately.
26. Before using the machine, check all screws and nuts particularly those holding the tools (conveyor
slats, swivel chute, gate, etc.). Tighten up if necessary. Also check drive chain and conveyor
chain tension and tighten up if loose.
27. Do not stand in the working area of the machine.
28. Beware! Crushing and shear zones may exist on remote controlled components, particularly
hydraulically or pneumatically-assisted ones.
29. Before getting down from the tractor or before any operations on the machine, switch off the
engine, remove the key from the ignition and wait until all moving parts are at a standstill.
30. Do not stand between the tractor and the machine until the parking brake has been applied and/
or chocks placed under the wheels.
31. Before working on the machine, make sure that it cannot be started up accidentally.
32. Do not use the loading components (gate) as lifting gear. Do not stand on these components.
HITCHING
1. On hitching or unhitching the machine from the tractor, put the hydraulic lift control lever in such
a position that the lift cannot be activated accidentally.
2. When hitching the machine to the tractor’s 3-point lifting system, make sure that the diameters of
the pins or trunnions correspond to the diameter of the tractor ball joints.