KUHN PRIMOR, Инструкция по эксплуатации

Страница: 36 / 54

36
MACHINE OPERATION
Read carefully before starting up the machine.
The machine must be used by one person only.
Before starting up the machine and beginning work, check around the machine
(beware of children!). Make sure that you have sufficient visibility.
Keep people away from the danger area of the machine.
Beware! When operating the loading components (arm, grab, machine body),
make sure that there can be no accidental contact with a power line.
Never stand beside the distribution chute while the machine is in operation.
Before starting up, check that the machine is in good condition, the tension of
the chains is correct, the components are properly greased and the screws
are tight.
Before commencing any manoeuvres in reverse gear or operating the loading
gear, sound the horn twice.
1. LOADING BALES
Before loading a bale (round or rectangular), position it in the good direction ie:
- round bale: in the unrolling direction
- rectangular bale: the strings must be at the side of the bale
- It is recommended to make the bale supported by a strongly built obstacle (wall, post). Never use a
pile of bales as a support. There is a risk of collapse.
- Couple the machine (see the Chapter on “Starting up” ).
- Using the control levers, lower the gate as close as possible to the ground (see the Chapter on
“Descriptions of controls”)
- Position together the tractor/machine exactly in the axis of the bale.
- Reverse slowly until the gate slides under the bale. Make sure the bale is well centered.
- Keep reversing until the bale is safely on the gate.
- Raise the gate until the bale is in a stable position.
- Stop the engine. Remove the ignition key.
- Cut the strings around the bale.