
Putting into service
Disc mower
GMD350 - 350-FF
37
Primary PTO shaft
The tractor PTO stub must rotate at a speed of 540 min
-1
.
Separate the two half PTO shafts and connect them to
the machine's input shaft and to the tractor PTO stub.
Check the length of the PTO shaft:
- When the PTO shaft is in its maximum overlap
position (retracted), tubes should not butt against the
yokes. . As a safety measure, a clearance (L) of at
least 25 mm (1’’) must be maintained.
- When the PTO shaft is in its maximum extended
position, the tube overlap must be more than
250 mm (10’’).
If this is not the case:
• Mark length (H) to cut when the transmission is the
maximum overlap position.
• Shorten the guard tubes and the transmission tubes
by the same length.
• Bevel and clean the tubes.
• Grease the inside of the outer tube.
Never operate the PTO shaft at an angle X exceeding
30°.
Make sure that the PTO shaft is correctly
adjusted, to avoid premature wear and tear.
Proceed with checks with the mowing unit
lowered and pivoted frontwards.
To avoid serious accidents, the PTO drive
shaft guards must be properly in place and
fixed with the chains provided.
Содержание GMD350
