KTM 690 Enduro R AUS/UK 2012, Руководство по ремонту

Страница: 99 / 234

15 BRAKE SYSTEM
97
202057-10
–
Cover the painted parts.
–
Take off screw cap
1
with the washer and membrane.
–
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill with
fresh brake fluid.
Bleed syringe (50329050000) ( p. 215)
Brake fluid DOT 4 / DOT 5.1 ( p. 210)
202055-10
–
Mount bleeder cover
2
.
Bleeder cover (00029013004) ( p. 214)
–
Connect the bleeding device.
Bleeding device (00029013100) ( p. 214)
201494-12
–
Open shut-off valve
3
.
Info
Follow the operating instructions of the bleeding device.
–
Ensure that the inflation pressure is correctly set at pressure gauge
A
. If neces-
sary, adjust the inflation pressure at pressure regulator
B
.
Guideline
Inflation pressure 2… 2.5 bar (29… 36 psi)
202056-10
–
Pull off protection cap
4
of the bleeder screw. Connect the hose of the bleeder
bottle.
Bleeding device (00029013100) ( p. 214)
–
Open bleeder screw
5
by approx. one-half turn.
Info
Bleed until fresh brake fluid emerges from the bleeder bottle hose without
bubbles.
–
Tighten the bleeder screw.
–
Close shut-off valve
3
.
–
Open the bleeder screw again until brake fluid stops emerging.
Info
This prevents overfilling of the brake fluid reservoir.
–
Tighten the bleeder screw. Remove the hose of the bleeder bottle. Mount the pro-
tection cap.
–
Disconnect the bleeding device. Remove the bleeder cover.
202057-11
–
Add brake fluid to the MAX mark
C
.
Brake fluid DOT 4 / DOT 5.1 ( p. 210)
–
Mount the screw cap with the washer and membrane.
Info
Clean up overflowed or spilt brake fluid immediately with water.