KTM 690 Enduro R AUS/UK 2012, Руководство по ремонту

Страница: 128 / 234

17 ENGINE
126
302151-10
Main work
–
Position the crankshaft with the special tool
1
in the press.
Under part, pressing-out tool (75029047051) ( p. 220)
–
Position the special tool
2
between the crankwebs.
Upper part, pressing-out tool (75029047050) ( p. 220)
–
Press the crank pin with the push-out drift of the special tool out of the upper
crankweb.
Pressing device for crankshaft, complete (75029047000) ( p. 219)
Info
Hold the lower crankweb.
–
Take off the connecting rod and bearing.
300138-10
–
Press the crank pin out of the crankweb.
300140-10
–
Press in the new crank pin
3
as far as possible.
Info
The crank pin must be pressed in so that oil channel
A
is aligned with oil
channel
B
.
If the oil channels are not correctly aligned, the conrod bearing will not be
supplied with oil.
–
Blow compressed air through the oil channel to check that it is clear.
300141-10
–
Install the bearing
4
and the connecting rod
5
.
Info
Thoroughly lubricate the bearing.
300142-10
–
Position special tool
6
on the press.
Pressing device for crankshaft, complete (75029047000) ( p. 219)
–
Place the crankweb in with the connecting rod and the bearing. Position the second
crankweb.