KTM 690 Enduro R AUS/UK 2012, Руководство по ремонту

Страница: 127 / 234

17 ENGINE
125
17.4.3 Work on the clutch cover
300097-10
–
Remove the shaft seal ring
1
of the crankshaft.
–
Press in a new shaft seal ring with the open side facing inward until it stops.
Info
Support the clutch cover sufficiently when pressing in.
–
Blow compressed air through the oil channel and check that it is clear.
17.4.4 Removing crankshaft bearing inner ring
302145-10
–
Fix the crankshaft with special tools
1
and
2
in the vise.
Upper part, pressing-out tool (75029047050) ( p. 220)
Under part, pressing-out tool (75029047051) ( p. 220)
302146-10
–
Heat the special tool
3
.
Guideline
150 °C (302 °F)
Tool for inner bearing race (58429037043) ( p. 215)
–
Push the heated special tool
3
on to the inner bearing race, press them hard
together, and pull them together off the crankshaft.
–
Take off the compensation shim.
–
Repeat the operation on the opposite side.
17.4.5 Removing balancer shaft drive wheel
Preparatory work
–
Remove the crankshaft bearing inner ring. ( p. 125)
302147-10
Main work
–
Screw in 2 M6 screws
1
in the threads. Tighten the two screws evenly to pull the
drive wheel
2
off the crankshaft.
17.4.6 Changing the connecting rod, conrod bearing, and crank pin
Preparatory work
–
Remove the crankshaft bearing inner ring. ( p. 125)
–
Remove the drive wheel of the balancer shaft. ( p. 125)