KTM 690 Enduro R AUS/UK 2012, Руководство по ремонту

Страница: 173 / 234

20 LUBRICATION SYSTEM
171
–
Change the oil filter. Check oil pumps for wear. Check that all oil holes are
clear.
–
Switch off the engine.
Warning
Danger of burns
Some vehicle components get very hot when the machine
is driven.
–
Wear appropriate protective clothing and safety gloves. In case of burns,
rinse immediately with lukewarm water.
–
Remove the special tools.
–
Mount and tighten screw
1
.
Guideline
Screw, unlocking of timing chain ten-
sioner M10x1 10 Nm (7.4 lbf ft)
Finishing work
–
Check the engine oil level. ( p. 169)
20.4 Changing the engine oil and filter, cleaning the oil screens
601022-10
–
Drain the engine oil. ( p. 171)
–
Remove the oil filter. ( p. 172)
–
Clean the oil screens. ( p. 173)
–
Install the oil filter. ( p. 172)
–
Fill up with engine oil. ( p. 174)
20.5 Draining the engine oil
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
Preparatory work
–
Remove the engine guard. ( p. 36)
100200-10
Main work
–
Place a suitable container under the engine.
–
Remove the oil drain plug
1
with the magnet and seal ring.
–
Completely drain the engine oil.