KTM 690 Enduro R AUS/UK 2012, Руководство по ремонту

Страница: 187 / 234

23 CLEANING/PROTECTIVE TREATMENT
185
23.1 Cleaning the motorcycle
Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
–
When cleaning the vehicle with a pressure cleaner, do not point the water jet directly onto electrical components, connectors,
cables, bearings, etc. Maintain a minimum distance of 60 cm between the nozzle of the pressure cleaner and the component.
Excessive pressure can cause malfunctions or destroy these parts.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
If you clean the motorcycle regularly, its value and appearance will be maintained over a long period.
Avoid direct sunshine on the motorcycle during cleaning.
401061-01
–
Seal the exhaust system to keep water out.
–
First remove coarse dirt particles with a gentle spray of water.
–
Spray very dirty areas with a normal motorcycle cleaner and then clean with a
brush.
Motorcycle cleaner ( p. 213)
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to the dry vehicle; always rinse with water
first.
If the vehicle was operated in road salt, clean it with cold water. Warm
water enhances the corrosive effects of salt.
–
After rinsing the motorcycle with a gentle spray of water, allow it to dry thoroughly.
–
Remove the plug from the exhaust system.
Warning
Danger of accidents Reduced braking efficiency due to a wet or dirty brake
system.
–
Clean or dry a dirty or wet brake system by riding and braking gently.
–
After cleaning, ride a short distance until the engine reaches operating tempera-
ture.
Info
The heat produced causes water at inaccessible locations in the engine and
brake system to evaporate.
–
Push back the protection covers of the handlebar controls to allow any water that
has penetrated to evaporate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
–
Clean the chain. ( p. 80)
–
Treat bare metal parts (except for brake discs and exhaust system) with
anti-corrosion materials.
Cleaning and preserving materials for metal, rubber and plastic ( p. 212)
–
Treat all painted parts with a mild paint polish.
High-luster polish for paint ( p. 212)
–
Treat all plastic parts and powder-coated parts with a mild cleaning and care agent.
Paint cleaner and polish for high-gloss and matte finishes, bare metal and plastic
surfaces (
p. 213)
–
Lubricate the ignition/steering lock.
Universal oil spray ( p. 213)