Kontron TIGW1U, Руководство по эксплуатации продукта, Страница: 58 / 104

TIGW1U server—Server Installations and Upgrades
Kontron Carrier Grade Server TIGW1U
Product Guide, rev. 1.3 December 2009
58
3.5.3.2 Replacing the Light Pipe Assembly
To replace the light pipe assembly on an existing SFP board, use the following
instructions, but replace the existing SFP board instead of installing a board:
• Removing the SAS Front Panel (SFP) Board
• Replacing the Light Pipe Assembly (the steps below)
• Installing the SFP Board
1. Note the position of the light pipe assembly so youcan later correctly position it on
the SFP board during the re-installation process. The pipes extend outward from
the SFP board to the front panel control panel.
2. Remove the light pipe assembly by gently pressing the four plastic clips from the
underside of the SFP board until the bottom of the clips are flush with the bottom of
the SFP board.
3. Ease the light pipe assembly from the SFP board.
4. Insert the four plastic clips on the light pipe assembly into the matching holes in
the new SFP board. Insert the clips gently and evenly; do not insert one clip fully
without first partially pressing the others into place.
3.5.3.3 Installing the SFP Board
1. Lower the SFP board into the chassis.
2. While holding the rear edge of the board, ease the board forward, sliding the serial
port and USB port connector assembly through the matching cutout at the front
panel of the chassis.
3. Lower the rear of the board into position, fitting the board over the placement
pegs. ("B")
4. Pull the board forward, locking the board onto the placement pegs. ("B")
5. Replace the screws you removed earlier. (“C”)
Figure 47. Installing the SFP Board
C
A
TS000206
B
A