Kontron TIGW1U, Руководство по эксплуатации продукта, Страница: 37 / 104

Kontron Carrier Grade Server TIGW1U
December 2009 Product Guide, rev. 1.3
37
Server Installations and Upgrades—TIGW1U server
4. Note the location of the alignment notch. (“B”)
5. Insert the DIMM making sure the connector edge of the DIMM aligns correctly with
the slot. (“E”)
6. Using both hands, push down firmly and evenly on the DIMM until it snaps into
place and both levers close. (“C” and “D”)
IMPORTANT: Visually check that each latch is fully closed and correctly engaged
with each DIMM edge socket.
7. Replace the processor air duct and the chassis cover if you have completed all work
inside of the server.
3.4.3.2 Removing DIMMs
To remove or replace a DIMM, follow these steps:
1. Remove the processor air duct. For instructions, see Section 3.2.5, “Removing the
Processor Air Duct” on page 26 .
2. Locate the DIMM(s) and select the one to be removed or replaced. See Figure 19 .
3. Open the DIMM socket levers.
4. Holding the DIMM by the edges with both hands, lift it away from the socket and
store it in an anti-static package.
5. If you are replacing the DIMM, follow the instructions in Section 3.4.3.1, “Installing
DIMMs” on page 36 .
6. Replace the chassis cover if you have completed all work inside of the server.
3.4.4 Adding or Replacing a Processor
Note: Use the instructions below to add or replace a processor instead of using the
instructions that came with the processor.
Caution: The processor must be appropriate: You could damage the server board if you install a
processor that is inappropriate for your server. Go to http://us.kontron.com/support/
for a list of compatible processors for the TIGW1U server.
3.4.4.1 ESD and Handling Processors
• When opening a socket, do not touch the gold socket wires.
• When unpacking a processor, hold it only at the edges to avoid touching the gold
contacts.
• Reduce the risk of electrostatic discharge (ESD) damage to the processor by doing
the following:
— Touch the metal chassis before touching the processor or server board.
— Keep part of your body in contact with the metal chassis to dissipate the static
charge while handling the processor.
— Avoid moving around unnecessarily.
— Use a ground strap attached to the front panel (with the bezel removed.)